NEL-1018

Technical data:

Viscosity-temperature curve:

Instructions:

1.The recommended operationtemperature is around 100℃. Adjust the temperature (especially the temperature of the glue roller) according to the environmental temperature, startup speed, glue consumption, fabric density , etc. to ensure the laminate  It is recommended to avoid being placed at high temperature (≥ 130 ℃) for a long time (≥ 2h), otherwise the viscosity will increase rapidly, and in extreme cases, gel, caking and other phenomena will occur, affecting the use of the product;

2.Coating way：Normally: Rolling coating；

3.Coating weight：Suggestion: Around 25g/㎡(depends on substrates and application)；

4.Attention：When the adhesive contact with air, it will react with moisture in the air, causing problems such as skinning and increased viscosity. If the machine is shut down for more than 2 hours, the lamination machine must be turned off. The glue in the glue tank needs to be cleaned thoroughly.

Curing:

1.At the room temperature 25℃ and 60% relative humidity, can get 80% curing after 12hours. Higher temperature and humidity will increase the curing speed.

2.The thickness of the adhesive layer, temperature, humidity will affect the curing speed.

Storage:
1.Suggest to store at 0~40℃,dry and clean environment.

2.12 months shelf time from the production date in original package.

Package:

200kg/drum

Safety advice:

Read the safety data sheet, follow the operating steps, ensure the safety and controllability before the operation.

Disclaimer:

The information provided in this TDS is for reference. We strongly recommend the detailed testing before purchasing to determine the suitability of the product for the specified purpose. If there are any changes in materials or conditions, the test should be repeated multiple times. We do not assume any legal responsibility for the information in this TDS or any other written or oral advice related to the product, except as otherwise expressly agreed and for any personal injury or death caused by our negligence and any legal liability under applicable mandatory product liability regulations.