NEL-1050

Technical data:

Instructions:

1.This product is suitable for spraying, roller coating and brush coating etc. The proper caliberof machine gun is 1.3-2.0mm. The air pressure should be more than 4kg, atomization effect will be worse due to small gas amount or low air pressure, surely depending on different

2.Adhesive Quantity：Suggestion: Around 25g/㎡，depends on substrates and application；

3.The adhesive should be cured as soon as possible after working, to avoid the adhesive layerloses adhesion.

4.If the viscosity is too large, a proper amount of ketone solvent or ethyl ester can be addedfor dilution and the amount should be less than 10%.

5.When do the foam spraying, the adhesive point is going to be large, nonuniform or infiltrateinto materials if the gun is too close to foam. Meanwhile, not be far away from the coated toavoid the adhesive being misty in the air. The recommended distance is 20-30cm.

Storage:
1.Suggest to store at 0~40℃,dry and clean enviroment.

2.6 months shelf time from the production date in original package.

Package:

18kg，190KG/drum；

Safety advice:

Read the safety data sheet, follow the operating steps, ensure the safety and controllability before the operation.

Disclaimer:

The information provided in this TDS is for reference. We strongly recommend the detailed testing before purchasing to determine the suitability of the product for the specified purpose. If there are any changes in materials or conditions, the test should be repeated multiple times. We do not assume any legal responsibility for the information in this TDS or any other written or oral advice related to the product, except as otherwise expressly agreed and for any personal injury or death caused by our negligence and any legal liability under applicable mandatory product liability regulations.